Accent Lighting - Grommet Snap Fit - Pair

Accent Lighting - Grommet Snap Fit - Pair

These LED's are Perfect accent lighting, Sensor Lighting, Turn Signal Arrays or just about anything else you can imagine, the possibilities are almost endless.

These LED's feature a small plastic shroud, this makes installation a breeze, simply drill a hole and snap the Plastic Shroud in place, then insert the LED and you have an LED Accent light, Brake light or turn signal with a clean, professional look.

On a Honda 600rr (Pictured Below) we installed 2 White LED's in the Rear Hugger, it took about 30 minutes to install. The LED's have a very low profile so the wires do not get in the way of the tire, we used Epoxy to make the bottom of the Hugger watertight and protect the wires we had to run.

We also put 2 Blue LED's behind th Radiator, they glow very nicely at night. Red LED's can be added to the rear to increase visibility at the back.

Stats:

Sold as a pair.

Available in Red, Blue, Amber, Green or Purple (use the drop down box to select)

High Power LED's

Wiring: Two Wire, 12 Volt Systems - They include Resistors

Bulb: 5mm High Intensity LED